| Author |
Message |
|
ppardee
|
Post subject: Control Lines remain unchanged in non-visible area  Posted: Thu Jul 31, 2008 5:12 am |
|
Joined: Sun Jul 27, 2008 7:10 pm
Posts: 11
|
|
Don't know if this is working as designed. I had a bone fortress, it got destroyed (don't think it should have been but I wasn't paying close enough attention to be sure). After it was destroyed I wasn't able to see the edge of what used to be my controlled area. The controlled area outline for me didn't change. Am I able to control area that I can't see? If not, is it possible to fix this? It just confused me a bit when I saw it.
|
|
  |
|
 |
|
jed
|
Post subject: Re: Control Lines remain unchanged in non-visible area Posted: Thu Jul 31, 2008 1:39 pm |
|
Joined: Tue Jan 08, 2008 2:07 am
Posts: 1045
|
|
Well there are cases where you can control areas you don't see. When you can no longer see a space it just shows what it was like when you last saw it. So it is working how we intended but maybe that is too confusing?
|
|
| |
|
|
|
ppardee
|
Post subject: Re: Control Lines remain unchanged in non-visible area Posted: Fri Aug 01, 2008 6:04 pm |
|
Joined: Sun Jul 27, 2008 7:10 pm
Posts: 11
|
|
If there are cases where it is possible to control a space that you cannot see, then it makes sense to keep the control lines visible even in the non-visible space, but if there is a way to clear control lines in areas that are not visible, it would be cool.
|
|
| |
|
|
|
